
SUNLU FC01 Filament Connector for 1.75mm Filament
The SUNLU FC01 is a compact heated filament splicer for joining short lengths of compatible 1.75mm 3D printing filament. It is useful when a spool has too little material left for a project or when you want to arrange different colours in one continuous length. This listing is for one Black FC01 connector, not a filament dryer, extruder or automatic multi-material printing system. Filament, printed models and workshop equipment shown in application photographs are not included.
Reuse compatible filament ends
The connector brings two prepared filament ends together inside a small fusion sleeve. Join the same material type to itself, such as PLA to PLA or PETG to PETG, even when the colours differ. Do not treat the list of supported plastics as permission to weld unrelated materials together. SUNLU lists PLA, ABS, PETG, PCL, PA and PC as supported material families. The FC01 is intended for 1.75mm filament, not 2.85mm or 3mm filament.
For colour experiments, the lengths you join determine when the printer reaches each colour. The FC01 does not place colour transitions at an exact layer automatically, and it does not replace a printer's multi-material system. Check the finished joint for an even diameter and adequate strength before feeding it into the printer. Results depend on filament condition, preparation and the chosen material profile.
Heating and everyday operation
A display shows the selected material and temperature, while the transparent upper cover lets you observe the joining area. SUNLU gives a maximum operating temperature of 240°C and a PLA warm-up reference of approximately three minutes to 185°C. Other materials use different presets and may need longer to heat. Prepare dry filament, follow the supplied instructions for sleeve placement, and allow the joint to cool before removing the sleeve or testing it.
The FC01 uses a 5V 2A power input. A suitable power adapter is required separately; the manufacturer states that an adapter is not included. Use the specified cable and power supply rating rather than assuming a low-current USB port will run the heater. The compact enclosure measures 111 x 79.4 x 38mm and has a stated net weight of 143g, making it easy to keep beside a desktop printer.
Specifications
| Brand / model | SUNLU FC01 Filament Connector |
|---|---|
| Colour | Black |
| Compatible filament diameter | 1.75mm nominal; manufacturer reference 1.75 ±0.03mm |
| Material families | PLA, ABS, PETG, PCL, PA and PC; join matching material types |
| Maximum operating temperature | 240°C |
| PLA warm-up reference | Approximately 185°C in 3 minutes |
| Power input | 5V 2A; power adapter not included |
| Dimensions | 111 x 79.4 x 38mm |
| Net device weight | 143g |
| Package contents | 1 x SUNLU FC01 filament splicer |
Hot-surface precautions
The internal joining area remains hot during use. The manufacturer's instructions warn that the inner black cover can reach approximately 50-100°C, despite the insulated design. Do not touch it directly. Operate on a stable, heat-resistant surface, keep hands clear of the heater and cutting area, and disconnect power when finished or unattended. Read the operating instructions before the first splice.