
Triple Axis Accelerometer Breakout - LIS3DH (with Headers)
This SparkFun breakout puts STMicroelectronics' LIS3DH - a low-power, three-axis capacitive MEMS accelerometer with 12 bits of resolution - on a breadboard-friendly board with the male headers already soldered in. It adds translation and movement sensing (3DoF) to a project and, unlike a bare IMU, also exposes three analog input channels plus built-in free-fall, motion and orientation detection.
Setup is simple: choose SPI or I2C, supply 3.3V and ground. The I2C address is jumper-selectable between 0x18 and 0x19. A 10-bit, 32-level FIFO buffers readings, and two interrupt outputs let the sensor wake the rest of your circuit on events. The board's soldered headers give the sensor a bit of mass, which brings readings closer to what a phone or finished project would see.
3.3V device: the LIS3DH is permanently damaged above about 3.6V. No level shifting is needed for I2C from a 3.3V Arduino supply; SPI use with 5V logic needs a level shifter.
Features
- STMicroelectronics LIS3DH three-axis capacitive MEMS accelerometer, 12-bit resolution
- Supply range 1.7V to 3.6V (use 3.3V; not 5V tolerant)
- SPI or I2C interface; I2C address selectable 0x18 / 0x19
- Full scale dynamically selectable: ±2g / ±4g / ±8g / ±16g
- 10-bit, 32-level FIFO buffer
- Free-fall detection, motion detection and 6D/4D orientation detection
- Three auxiliary ADC input pins (A1-A3) and two interrupt outputs
- Embedded temperature sensor
- Male headers pre-soldered - ready for a breadboard
Package Includes
- 1x SparkFun Triple Axis Accelerometer Breakout - LIS3DH (with headers soldered)
Not included: microcontroller, breadboard and jumper wires are sold separately.