
SparkFun Qwiic ToF Imager - VL53L5CX
The SparkFun Qwiic ToF Imager is built around the VL53L5CX from STMicroelectronics, a time-of-flight sensor that captures a grid of distance measurements instead of a single-point reading. Using a SPAD array with physical infrared filters and diffractive optical elements, it reports an 8x8 (64-zone) depth image with a wide 63-degree diagonal field of view - closer to low-resolution vision than a simple proximity check. Ranging works out to 4 meters across all zones at up to 15Hz, with frame rates up to 60Hz in reduced-zone modes.
All communication runs over I2C through the Qwiic connect system, so no soldering is needed; 0.1-inch-spaced pins are also broken out for breadboard use. ST's histogram-based algorithms let the sensor detect multiple objects within the field of view and resist crosstalk from cover glass beyond 60cm. An autonomous low-power mode can wake the host through a programmable interrupt threshold.
Controller compatibility: the VL53L5CX loads its firmware (about 90KB) over I2C every time it powers on, so standard 8-bit microcontrollers such as the Arduino Uno do not have enough flash memory to drive it. Use a board with sufficient memory, such as a SparkFun Artemis, an ESP32 board, or a Raspberry Pi RP2040/RP2350 board. The sensor can also be automatically detected, configured and logged by SparkFun DataLogger hardware without coding.
Features
- STMicroelectronics VL53L5CX multizone time-of-flight sensor
- 4x4 or 8x8 separate ranging zones (up to 64 zones simultaneously)
- Ranging up to 400cm; up to 60Hz frame rate capability (15Hz at 8x8)
- 63-degree diagonal square field of view via diffractive optical elements on transmitter and receiver
- Emitter: 940nm invisible-light VCSEL with integrated analog driver
- Multi-object detection and cover-glass crosstalk immunity (beyond 60cm) via ST histogram algorithms
- Autonomous low-power mode with programmable interrupt threshold to wake the host
- Operating voltage: 3.3V; I2C address 0x52
- 2x Qwiic connectors; 0.1-inch-spaced pins broken out
Package Includes
- 1x SparkFun Qwiic ToF Imager - VL53L5CX
Not included: Qwiic cable, microcontroller and headers are sold separately. Requires a host with enough flash to load the sensor firmware (see description).