SparkFun NanoBeacon Board - IN100
The SparkFun NanoBeacon Board is a 2.4GHz Bluetooth Low Energy beacon breakout built around the InPlay IN100 NanoBeacon module. The IN100 is compliant with several standard 2.4GHz beacon protocols - including BT, Google Eddystone and Apple iBeacon - and is designed for exceptionally low power draw (under 650nA in sleep mode), so a beacon can run in the field for years on a coin cell. It suits wireless sensor monitoring, asset tracking, retail beacons, or building your own tag for real-time location monitoring.
Setup needs no firmware work: the InPlay NanoBeacon Config Tool provides a graphical interface for configuring advertising, pairing and data packets without writing code. A 12mm coin-cell holder on the board accepts a 3V CR1225 battery (not included). For integration, the board offers a vertical Qwiic connector for solderless I2C sensors, a 3.3V UART breakout for a direct Serial Basic connection, four GPIO pins (4-7) and two I/O power-switch pins (SW0, SW1).
This version of the board is built for rapid implementation: male headers come pre-soldered on the 0.1-inch-spaced through-hole pins, and the power LED and reset button are not populated. (SparkFun also offers a Lite version without these extras.)
Important configuration warning: when programming the IN100 with the InPlay NanoBeacon Config Tool, the "Burn/Program" option uploads the settings and permanently locks the module - this cannot be undone and can brick the IN100. Use the tool's "Run in RAM" testing mode first and make sure everything works as intended before burning; note that I2C is not available in RAM testing mode, so I2C sensor code should be verified before clicking "Burn/Program".
Features
- InPlay IN100 NanoBeacon 2.4GHz BT beacon module
- Supply voltage range: 1.1V to 3.6V
- Ultra-low power: under 650nA in sleep mode
- Beacon modes: Proprietary, BT, Google Eddystone and Apple iBeacon compliant
- Pre-soldered male headers on through-hole pins: 3.3V UART, 4x GPIO, 2x switch pins
- Coin-cell battery holder for a 3V CR1225 battery (battery not included)
- 1x vertical Qwiic connector for solderless I2C sensors
- Code-free setup with the InPlay NanoBeacon Config Tool
Package Includes
- 1x SparkFun NanoBeacon Board - IN100 (with pre-soldered male headers)
Not included: CR1225 coin cell battery, Qwiic cable, sensors and USB-to-serial adapter are sold separately.