
The SparkFun GPS-17285 is a NEO-M9N GNSS breakout for projects that need an external SMA-connected antenna. Its u-blox M9 receiver can track GPS, GLONASS, Galileo and BeiDou together, while Qwiic connectors and broken-out pins provide practical ways to connect a host controller.
This is the SMA version, not the GPS-15712 U.FL board or GPS-15733 chip-antenna version. An external GNSS antenna is required and is not included. It is a positioning receiver, not a magnetic compass or an RTK base/rover system.
Features
- 92-channel u-blox NEO-M9N receiver with four-constellation tracking.
- SMA socket for a separately purchased compatible GNSS antenna.
- Qwiic I2C connectors, USB-C connection and accessible signal pads.
- Rechargeable backup cell for retaining receiver data between powered sessions.
- Configurable update rate and receiver settings using supported u-blox software or SparkFun's Arduino library.
- Power and pulse-per-second indicator LEDs.
Specifications
- Manufacturer part number: GPS-17285
- Receiver: u-blox NEO-M9N, 92 channels
- GNSS systems: GPS, GLONASS, Galileo and BeiDou
- Antenna connector: SMA; antenna sold separately
- Maximum navigation update rate: up to 25Hz, configuration dependent
- Manufacturer-rated horizontal accuracy: approximately 1.5m under suitable conditions; not a guaranteed field result
- Module supply and logic level: 3.3V
- Typical tracking current: approximately 31mA for GPS and GLONASS
- Interfaces: Qwiic I2C, UART and USB-C; follow the hookup guide for alternate pin functions
- Protocols: NMEA, UBX and RTCM support, subject to receiver configuration
- Board footprint: approximately 40.64 x 36.83mm, excluding connector projection
- Typical manufacturer-listed cold/hot start: 24 seconds / 2 seconds, dependent on retained data and reception
Connection and Setup
Connect a suitable SMA GNSS antenna and place it with a clear view of the sky. Use the official hookup guide to choose USB-C, Qwiic I2C or the breakout pins. The receiver logic is 3.3V. Do not connect 5V logic directly to the signal pins or confuse the regulated input with the 3.3V supply pin.
Use SparkFun's u-blox GNSS library or supported u-blox configuration software to set output messages, rate and communication settings. Backup-cell retention and hot-start results depend on charge state, elapsed time and signal conditions. This board does not provide centimeter-level RTK positioning merely because it supports RTCM messages.
Package Includes
- 1 x SparkFun GPS-17285 NEO-M9N SMA GPS breakout board with Qwiic connectors.
No GNSS antenna, USB cable, Qwiic cable, headers, host controller or battery pack is included. The onboard backup cell is part of the board and does not power the complete receiver during normal use. Rulers in the scale photo are not included. The application photo shows a separately purchased RedBoard, antenna and cables for connection reference only.