
Build a compact GNSS receiver into a logger, navigation prototype or controller project with the SparkFun GPS-15733. This NEO-M9N breakout combines a u-blox M9 receiver with an onboard chip antenna, so a separate antenna is not needed for the board's standard setup.
The GPS-15733 is the chip-antenna version. It is different from the GPS-15712 U.FL and GPS-17285 SMA versions. Qwiic I2C connectors, USB-C and breakout pads offer several ways to connect a host. This is a positioning receiver, not a magnetic compass or centimeter-accuracy RTK system.
Features
- 92-channel u-blox NEO-M9N receiver.
- Concurrent reception of GPS, GLONASS, Galileo and BeiDou.
- Integrated chip antenna for a self-contained receiver board.
- Qwiic I2C connectors plus USB-C and accessible signal pads.
- Onboard rechargeable backup cell helps retain receiver data between powered sessions.
- Configurable output messages, rate, geofencing and receiver functions.
Specifications
- Manufacturer part number: GPS-15733
- GNSS module: u-blox NEO-M9N, 92 channels
- Antenna: onboard chip antenna
- Maximum navigation update rate: up to 25Hz, configuration dependent
- Manufacturer-rated horizontal accuracy: approximately 1.5m under suitable conditions, not a guaranteed field result
- Module supply and I/O level: 3.3V
- Typical tracking current: approximately 31mA for GPS and GLONASS
- Connections: Qwiic I2C, UART and USB-C; see the guide for other pin functions
- Protocols: NMEA, UBX and RTCM support, subject to receiver configuration
- Board footprint: approximately 40.64 x 33.02mm, excluding connector projection, from the official dimension drawing
- Typical manufacturer-listed cold/hot start: 24 seconds / 2 seconds, dependent on retained data and reception
Connection and Setup
Place the antenna side with a clear view of the sky, away from electrical noise and shielding. Use the official hookup guide to connect through USB-C, Qwiic or the breakout pads. Signal pins use 3.3V logic. Do not apply 5V logic to them or confuse regulated power input with the 3.3V supply pin.
Configure the receiver with SparkFun's u-blox GNSS Arduino library or compatible u-blox software. Acquisition time and accuracy depend on reception, configuration and retained data. The backup cell is for receiver state retention, not the normal power supply for the complete board. RTCM protocol support alone does not make this an RTK base or rover.
Package Includes
- 1 x SparkFun GPS-15733 NEO-M9N GPS breakout board with chip antenna and Qwiic connectors.
No USB cable, Qwiic cable, pin headers, host controller or external battery pack is included. The chip antenna and onboard backup cell are fitted to the board. Rulers in the scale photograph are reference items, not package contents. The antenna detail image highlights the antenna position on this exact board.