
Add a complete GNSS receiver to a data logger, drone, robot or navigation prototype with the SparkFun GPS-15210. This breakout pairs the u-blox SAM-M8Q receiver with a built-in chip antenna, SAW filter and LNA, so it works as a self-contained positioning module without an external antenna or RF wiring.
The SAM-M8Q is a smart antenna module: the antenna element is part of the receiver package itself. Qwiic I2C connectors allow solderless connection, while 0.1-inch pads and an FTDI header keep UART and advanced signal access available. This is a positioning receiver, not a compass or a centimeter-accuracy RTK system.
Features
- 72-channel u-blox SAM-M8Q GNSS receiver.
- Concurrent tracking of GPS, GLONASS and Galileo, with QZSS and SBAS (WAAS, EGNOS, MSAS, GAGAN) support.
- Integrated chip antenna with SAW filter and LNA for out-of-box reception.
- Two Qwiic I2C connectors plus 0.1-inch breakout pads and an FTDI serial header.
- Onboard rechargeable backup battery powers the RTC and retains orbit data for faster hot starts.
- Configurable through u-blox u-center software or the SparkFun u-blox GNSS Arduino library.
Specifications
- Manufacturer part number: GPS-15210
- GNSS module: u-blox SAM-M8Q, 72 channels
- Antenna: integrated chip antenna, part of the SAM-M8Q module
- Manufacturer-rated horizontal position accuracy: approximately 2.5m to 8.0m under suitable conditions, not a guaranteed field result
- Supply range: 2.7V to 3.6V; approximately 29mA in continuous mode and 9.5mA in power save mode
- Time to first fix (manufacturer figures): cold start approximately 26 seconds, aided start 2 seconds, reacquisition 1 second
- Maximum update rate: up to 18Hz single constellation, 10Hz concurrent, configuration dependent
- Interfaces: UART, I2C (DDC), configurable PPS output and external interrupt
- Protocols: NMEA, UBX and RTCM support, subject to receiver configuration
- Board dimensions: 40.64 x 40.64mm with four 4-40 compatible mounting holes, from the official dimension drawing
Connection and Setup
Give the antenna side a clear view of the sky, away from shielding and electrical noise. Connect through the Qwiic connectors for solderless I2C, or solder wires or headers to the 0.1-inch pads for UART, PPS, interrupt, safeboot and reset access. Signal pins use 3.3V logic; do not apply 5V logic to them.
Use the official hookup guide for wiring examples, and configure the receiver with the SparkFun u-blox GNSS Arduino library or u-blox u-center software. Acquisition time and accuracy depend on reception, configuration and retained data. The backup battery retains receiver state between sessions; it is not the board's main power supply. RTCM support alone does not make this board an RTK base or rover.
Package Includes
- 1 x SparkFun GPS-15210 SAM-M8Q GPS breakout board with chip antenna and Qwiic connectors.
No Qwiic cable, pin headers, host controller or USB cable is included. The chip antenna and backup battery are fitted to the board. Rulers in the scale photograph are reference items, not package contents. The RedBoard shown in the connection photograph is an example host, not part of the package.