
The SparkFun GPS-15136 GPS-RTK2 breakout carries the u-blox ZED-F9P dual-band GNSS receiver. It can work as a rover receiving RTCM correction data or as a fixed base station generating corrections after configuration. USB-C and two Qwiic connectors make it suitable for embedded positioning, mapping and robotics projects.
This is the U.FL GPS-RTK2 board, not the RTK-SMA version. An external GNSS antenna is required. Centimeter-level RTK positioning also needs suitable correction data and a valid RTK fix; the board alone is not a complete survey kit.
Features
- Concurrent GPS, GLONASS, Galileo and BeiDou reception with L1/L2 dual-band capability.
- Configurable rover and base-station operation with RTCM correction support.
- USB-C for power, configuration and serial data, plus dual Qwiic I2C connectors.
- Broken-out UART1, UART2/RTCM and control signals; selectable SPI interface shares pins with I2C and UART1.
- U.FL external antenna connector and PCB cut-out for an optional antenna-cable bulkhead.
- Rechargeable backup battery for configuration and orbit-data retention, with power, PPS, RTK and geofence status LEDs.
Specifications
- Manufacturer part number: GPS-15136
- Receiver family: u-blox ZED-F9P
- GNSS: GPS, GLONASS, Galileo and BeiDou
- Antenna port: U.FL, external antenna required
- Power: 5V input/USB or clean 3.3V input; all logic is 3.3V
- Typical current: 68-130mA, depending on constellation selection and tracking state
- Interfaces: USB, I2C, UART1, UART2 and selectable SPI
- Default I2C address: 0x42, software configurable
- Manufacturer-listed maximum rates: basic PVT up to 25Hz and RTK up to 20Hz, subject to firmware and receiver configuration
- Manufacturer-listed horizontal accuracy: 2.5m without RTK and 0.010m with RTK under applicable test conditions
- Typical time to first fix: 25 seconds cold, 2 seconds hot
- PCB outline: approximately 1.70 x 1.70 inches, 43.18 x 43.18mm; allow extra clearance for connectors
- Board weight: approximately 6.8g
- Two Qwiic connectors and four mounting holes
Connection and RTK Notes
Use a suitable external multi-band GNSS antenna to make use of dual-band reception. An SMA antenna needs a compatible U.FL-to-SMA cable. Mount the antenna with a clear view of the sky and follow its ground-plane requirements. Connectors, cables and antenna are separate accessories.
For RTK operation, provide suitable RTCM corrections from a base station or correction service. Service availability, coverage, account requirements and any fees are separate from this board. Do not assume centimeter accuracy without a valid RTK fix.
The DSEL jumper selects SPI in place of I2C and UART1 on their shared pins. USB and UART2 remain available as described in the hookup guide. Use 3.3V-compatible signal levels. The board is a GNSS receiver, not a complete flight controller.
Package Includes
- 1 x SparkFun GPS-15136 GPS-RTK2 ZED-F9P Qwiic breakout board with onboard backup battery.
GNSS antenna, U.FL-to-SMA cable, USB-C cable, Qwiic cable, headers, radio/Bluetooth module, base station, mounting hardware and host controller are not included. No correction-service subscription or redemption code is promised with this listing. Gallery images show different views and technical details of the same one-board model.