
The RadioMaster RP2 V2 is a nano-size ExpressLRS 2.4GHz receiver with a built-in ceramic antenna. It is intended for compact FPV and RC builds that use a CRSF serial receiver connection rather than direct PWM servo outputs.
A temperature-compensated crystal oscillator (TCXO) helps keep the receiver's frequency stable as temperature changes. The updated PCB places the status LED on top and provides solder pads for power and the serial connection. Built-in WiFi supports firmware updates and receiver setup through the ExpressLRS WebUI.
Supply regulated 5V and check the pad labels before soldering. Connect the receiver TX to the flight controller's RX and the receiver RX to the flight controller's TX on a suitable UART, then enable Serial RX and CRSF in the flight-controller settings. Use compatible ExpressLRS firmware and matching binding settings on the transmitter and receiver. This RP2 uses an onboard ceramic antenna; it is not the RP1 model with an external T-antenna connection.
Features
- ExpressLRS 2.4GHz receiver with CRSF serial interface
- Onboard ceramic antenna for a compact installation
- Built-in TCXO for temperature-compensated frequency control
- WiFi firmware updates and WebUI configuration
- Top-mounted status LED and accessible solder pads
- Suitable for compatible 2.4GHz ExpressLRS transmitters and modules
Specifications
- Model: RadioMaster RP2 V2
- Frequency band: 2.4GHz
- Receiver supply: 5V
- Output interface: CRSF serial
- Antenna: built-in ceramic / SMT antenna
- Telemetry RF power: 10mW
- Dimensions: 13 x 11 x 7mm
- Receiver weight: approximately 0.55g
- Firmware target: RadioMaster RP1/2 2400 RX
Package Includes
- 1 x RadioMaster RP2 V2 ExpressLRS receiver
- 1 x CRSF connection wire
- 1 x user manual card