
The RadioMaster R84 V2 is a four-channel PWM receiver for small RC models using a compatible multiprotocol-module radio. Its slim board, two antennas and direct servo outputs suit installations where space and weight are limited.
Check compatibility before ordering: The R84 V2 works with compatible MPM radios using D8, D16 v1 or S-FHSS mode. RadioMaster specifies MPM-radio use only, not native FrSky transmitters. This is not an ExpressLRS receiver and does not bind to an ELRS transmitter.
Features
- Four PWM output channels.
- Selectable D8, D16 v1 and S-FHSS compatible modes for MPM radios.
- Two 15cm antennas with UFL connections.
- On-board bind button and LED status indicator.
- Receiver failsafe setting through the bind button, as described in the official manual.
- Approximately 3g including both antennas.
Specifications
- Model: RadioMaster R84 V2
- Channels: 4
- Output: PWM
- Operating band: 2.4GHz, 2400-2483.5MHz
- Receiver supply: DC 4.5-8.4V
- Signal formats: D8 / D16 v1 / S-FHSS compatible, MPM radio only
- Antenna length: 15cm each, two antennas
- Size: approximately 30 x 15 x 5mm
- Weight: approximately 3g including antennas
Setup Notes
Use the official R84 V2 manual for the paired-channel connector pinout and check polarity before connecting power or servos. The receiver supply range does not mean every connected servo supports 8.4V. Use a suitable regulated supply and keep the antennas clear of conductive parts.
The manufacturer requires frequency fine tuning for D8 and D16 modes before use. Bind with the correct protocol, set and test failsafe, then perform a ground range check before flying. Actual range depends on the radio, antenna placement, interference and local conditions.
Package Includes
- 1 x RadioMaster R84 V2 receiver with two antennas.
Transmitter, multiprotocol module, servos, flight controller and battery are not included.