
Piezo Vibration Sensor - Small Vertical
The Piezo Vibration Sensor - Small Vertical (SparkFun SEN-09199) is a compact piezoelectric film vibration sensor built on the Minisense 100 from TE Connectivity's Measurement Specialties line, in its vertical-mount 100V variant (P/N 1005940-1), and sold by SparkFun for easy prototyping. It is a cantilever-type PVDF film element loaded with a small mass at the tip, which gives it high sensitivity at low frequencies, and it suits vibration, impact, tap and motion detection projects. This version comes with solder pins oriented for vertical mounting.
Because the film acts like a small voltage source with no internal limiting, sharp strikes can produce surprisingly high spikes. In measurements in SparkFun's hookup guide for this sensor family, an unloaded sensor spiked as high as about +20V and -12V - enough to permanently damage a microcontroller's ADC pins. The guide demonstrates one damping approach: a 1M ohm resistor wired in parallel with the sensor. In the guide's own measured example with an Arduino Uno on pin A0, that loading kept the spikes between -0.5V and +5V, within the ATmega328 I/O pin tolerance, and the guide also suggests zener-diode clamping or op-amp buffering as more robust options. Treat that circuit as the guide's starting example rather than universal safe wiring, and size the protection for your own setup.
The active sensor area is shielded for improved RFI/EMI rejection, and the rugged, flexible PVDF element withstands high shock overload. Typical datasheet figures at 25 deg C include 1.1 V/g open-circuit voltage sensitivity (6 V/g at the 75 Hz resonance), a +3 dB upper limiting frequency of 42 Hz, +/-1% linearity and 244 pF capacitance. The pins are solderable for PCB or perfboard mounting, and the sensor draws no supply current - it generates its own analog signal.
Features
- Minisense 100 cantilever-type PVDF vibration sensor with tip mass (TE Connectivity Measurement Specialties, vertical 100V variant)
- Analog output, no supply current needed
- 1.1 V/g typical open-circuit sensitivity, 6 V/g at 75 Hz resonance, usable below resonance up to about 40 Hz
- +/-1% linearity, wide dynamic range
- Shielded active area for RFI/EMI rejection, withstands high shock
- Solderable pins for vertical mounting; about 18 x 6 mm film element, 0.6 g (see dimension drawing)
- Operating temperature -20 to +60 deg C
Package Includes
- 1 x Piezo Vibration Sensor - Small Vertical (SparkFun SEN-09199 / TE Minisense 100V)
Not included: resistor, zener diode, breadboard, jumper wires or microcontroller - any Arduino, oscilloscope and accessories shown in guides or diagrams are for illustration only.