
The MK2B is the classic dual-power PCB heat bed for RepRap, Prusa i3 and other open-frame 3D printers. It runs on 12V or 24V depending on how the three power pins are wired, and provides a 214 x 214 mm heated platform for printing PLA, ABS and other filaments. Pair it with a borosilicate glass plate clipped on top for a flat printing surface.
Specifications
- PCB size: 214 x 214 mm (approx. 200 x 200 mm active heated area; 209 mm mounting hole spacing)
- Laminate: FR4, 1.6 mm
- Construction: 2-layer, 35 µm copper, red soldermask with white silkscreen on both sides
- Power input: 12V or 24V (dual power; wire the three on-board pins according to the printed pin table)
- Resistance: approx. 1.0-1.2 ohm in 12V wiring; approx. 3-3.4 ohm in 24V wiring
- Current draw: about 10A at 12V - make sure your power supply has at least 10A spare
- On-board LED/resistor pads and thermistor footprint (thermistor not included)
Package Includes
- 1 x MK2B 3D Printer PCB Heat Bed - 214mm
Useful Links
Safety
- Hot surface: the bed gets very hot in operation and stays hot after power-off. Before touching, power off the heat bed and wait at least 10 minutes.
- Do not leave the printer unattended while the bed is heating, and keep it away from children (warnings printed on the board by the designer).
- Use thick, short supply wires and secure screw-terminal connections - at 12V the bed draws about 10A.