Description:
The ATTiny85 based mini development board is similar to the Aduino, but cheaper and smaller (of course a bit less powerful). Power via USB or External Source - 5v or 7-35v (12v or less recommended, automatic selection).
With a whole host of shields to extend its functionality and the ability to use the familiar Aduino IDE, this board is a great way to jump into microcontroller electronics. Power via USB or External Source - 5v or 7-16v (automatic selection). On-board 150ma 5V Regulator. Built-in USB (and serial debugging). 6 I/O Pins (2 are used for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you are programming via USB) 8k Flash Memory (about 6k after boot loader) I2C and SPI (via USI) PWM on 3 pins (more possible with Software PWM) ADC on 4 pins Power LED and Test/Status LED
Features :
- High Performance, Low Power AVR® 8-Bit Microcontroller
- Non-volatile Program and Data Memories
- 8K Bytes of In-System Programmable Program Memory Flash
- Endurance: 10,000 Write/Erase Cycles
- 512 Bytes In-System Programmable EEPROM
- 512 Bytes Internal SRAM
- Peripheral Features
- Two High-Frequency PWM Outputs with Separate Output Compare Registers
- USI – Universal Serial Interface (12C, SPI, 1-wire) with Start Condition Detector
- 10-bit ADC
- 4 Single-Ended Channels
- Two Differential ADC Channel Pairs with Programmable Gain (1x, 20x)
- Speed Grade : 0 – 10 MHz @ 2.7 – 5.5V, 0 – 20 MHz @ 4.5 – 5.5V
- Industrial Temperature Range
- Low Power Consumption
- Active Mode:1 MHz, 1.8V: 300 µA
Package Included:
- 1 x Digispark ATTINY85 Mini USB Development Board
- 2 x Berg Pin
