
INSLOGIC PETG-CF10 Grey Filament, 1.75mm, 1kg
INSLOGIC PETG-CF10 combines a PETG base with 10% carbon fibre for FDM printing. This listing supplies one 1kg spool in Grey, with a nominal filament diameter of 1.75mm. Choose it when your project calls for the PETG-CF10 formulation rather than unfilled PETG, PETG Pro or PLA-CF. Its muted grey colour and matte surface are useful for practical models where a low-gloss finish is preferred.
For functional prototypes and detailed parts
The carbon fibre reinforcement is intended to improve stiffness while retaining useful toughness. INSLOGIC identifies tools, structural components and functional prototypes as applications for this material. It is a starting point for making brackets, housings, fit-check models and workshop fixtures, provided the finished design is tested for its intended conditions. A material choice alone does not establish the load capacity of a printed part.
The manufacturer describes low warping and good dimensional stability. Actual results still depend on bed preparation, first-layer calibration, part orientation and the printer's extrusion system. The matte finish can make surface reflections less prominent, but it does not remove layer lines or replace good print settings.
Printer setup and material care
Use an FDM printer that accepts 1.75mm filament and can operate at the required temperatures. INSLOGIC's current starting guidance is a 240-250°C nozzle, 50-60°C bed and 50-100mm/s print speed, with 100% cooling fan. These are tuning references, not guaranteed settings for every machine. Begin with a suitable material profile and check extrusion, bonding and surface quality on a small test before committing to a long print.
INSLOGIC states that PETG-CF10 is not compatible with any AMS series. Do not assume compatibility merely because a printer accepts other PETG materials. Check your feed path and printer manufacturer's instructions for reinforced filaments. The drying reference is 50-60°C for four hours. Store unused filament dry and protected from moisture, and use temperature-controlled drying equipment suitable for the spool.
Specifications
| Brand / formulation | INSLOGIC PETG-CF10, 10% carbon fibre reinforced PETG |
|---|---|
| Colour | Grey (#494D53 manufacturer colour reference) |
| Diameter | 1.75mm ±0.02mm |
| Net filament weight / nominal length | 1kg / 330m |
| Nozzle / bed temperature | 240-250°C / 50-60°C |
| Starting print speed / fan | 50-100mm/s / 100% |
| Drying reference | 50-60°C for 4 hours |
| Tensile strength / elongation at break | 36.7MPa / 35% |
| Flexural strength / modulus | 58MPa / 2835MPa |
| Heat deflection temperature | 73.5°C at 0.45MPa |
| AMS compatibility | Not compatible with any AMS series |
| Package contents | 1 x 1kg Grey PETG-CF10 filament spool |
Use notes
Mechanical and thermal figures are manufacturer laboratory references. Printed properties vary with geometry, orientation, settings and temperature. The heat-deflection figure is not a continuous-use temperature rating. Manufacturer application images illustrate the material family; shown printed objects, equipment and accessories are not included and may use another colour. Printed examples are not certification for protective or safety-critical use.