
The Holybro M9N Standard GPS combines a u-blox M9N multi-constellation GNSS receiver with an IST8310 compass, RGB status light, buzzer and safety switch. It connects to a compatible Pixhawk-standard GPS1 port through its ten-pin cable and includes a fixed carbon-fiber mounting set.
This listing is the original-style standard ten-pin M9N version with safety switch and buzzer, not the six-pin secondary GPS, the older Pix32 split-cable option, or the newer IP67 V2. Match the connector and firmware to your flight controller before ordering. The module is not an RTK receiver.
Features
- u-blox M9N GNSS receiver supporting concurrent GPS, Galileo, GLONASS and BeiDou reception.
- Integrated IST8310 magnetic compass.
- 25 x 25 x 4mm ceramic patch antenna.
- Tri-color status light, buzzer and physical safety switch.
- Standard ten-pin connection for a compatible GPS1 input.
- Fixed carbon-fiber GPS mount set included.
Specifications
- Model: Holybro M9N Standard GPS
- Connector option: standard JST-GH ten-pin, maker option 12027
- Receiver: u-blox M9N
- Compass: IST8310
- Supported output protocols: UBX and NMEA
- Serial baud rate: 115200bps
- Supplier-listed default update rate: 5Hz; configuration and firmware affect actual output
- Manufacturer-listed horizontal accuracy: 1.5m CEP, subject to reception conditions
- Input voltage: 4.7-5.2V DC
- Antenna: 25 x 25 x 4mm ceramic patch
- Original-style enclosure size: approximately 50mm diameter x 14.4mm
- Module and cable weight: approximately 32g, excluding mounting set
- Attached cable: approximately 26-27cm
- Operating temperature: -40 to 80 degrees C
Connection and Installation
Use a compatible ten-pin GPS1 port and check the official pin map before connecting. This is not the six-pin GPS2 version. The GPS serial connection, compass bus, safety switch, buzzer and status signals depend on correct controller wiring and firmware support. Follow the controller's GPS setup and compass-calibration instructions rather than assuming the unit is ready to fly after plugging it in.
Install the antenna with a clear view of the sky, away from power wiring and RF interference. Keep the compass away from magnetic materials and calibrate it after installation. This original-style version is not advertised here as waterproof or IP67. The weighing scale shown in one gallery photo is for illustration and is not included.
Package Includes
- 1 x Holybro M9N GPS module with standard ten-pin cable.
- 1 x fixed carbon-fiber GPS mounting set with its supplied mounting hardware.
No flight controller, aircraft, battery, RTK correction equipment or weighing scale is included. A six-pin secondary-GPS cable and a split Pix32 cable are not included. The first image shows the GPS and the supplied mounting set.