Description:
The F3 Brushed Flight Controller Board most recent iteration of the F3 Brushed Flight Control Board for Micro FPV Frame Brushed Flight Control is based on the SP Racing F3 EVO Brush and supports 6-axis multi-rotors. Every axis has a working current of at least 10A.
Improved voltage boost and reduction module satisfy the needs of small power devices like 25mW 2-in-1 camera and transmitter by providing 5V output and reliable 500mAh current output through UART1 or UART 2. It is compatible with the WS2812 colorful turning light and brake light due to its LED strip feature.
The F3 EVO Brushed Micro FPV Flight Controller firmware 32 brush flight control is used by the F3 Brushed Flight Control Board Based On SP Racing F3 EVO Brush for Micro FPV Frame. Both 1S (4.2V) and 2S (8.4V) power supplies are supported. Using 2S power may result in a more violent flying experience.
High-Performance Brushed Flight Controller For Micro Drones flight stability is guaranteed by the innovative hardware platform F3 with STM32F303CCT6 + MPU6500 processors. The operation current of large-current NMOS transistors can be as high as 10A. Moreover, PPM, SBUS, and DSM receiver input signals are supported.
Specifications:
- Item Type: Flight Controller
- Sensor: 6050 MCU
- Micro SD Card Slot (Y/N): No
Features:
- UART1/2 Output: 5V
- UART3 Output: 3.3V
- Use STM32F303CCT6 + MPU6500, advanced hardware platform F3 for higher flight stability
- Large current NMOS transistors, operating current can reach 10A or higher
- Each machine is equipped with freewheeling diodes
- Support PPM, SBUS, DSM receiver input signal
- Supported Receiver Input Signal: PPM, SBUS, DSM
- Run on SP RACING F3 EVO firmware 32 brush flight control
- Support 1S (4.2V) and 2S (8.4V) power supply, 2S power can bring a more violent flying experience
- Independent design of the circuit structure comes with pressure reduction technology, whether it is 1S or 2S power input, UART1/2 output 5V, UART3 output 3.3V
- Battery voltage detection and buzzer interface
- Compatible with almost all hollow cup motors, including 1020 coreless motor Notice: Before applying power, pay attention to the battery voltage selection. The default shipping is 1S (4.2V); 2S first needs to disconnect the short contacts 1S, and 2S and then connect two pairs of short. Prohibit the same three pads shorted together. Receiver configuration:
- DSM DSM receiver soldered directly to the interface 3.3V, GND, RX3, CF the software configuration UART3.
- PPM and SBUS receiver welded to the UART2 GND, + 5V, RX2 above, SBUS signal CF in the software configuration.
Package Included:
1 x F3 Brushed Flight Controller Board SP Racing Based On F3 EVO Brushed Micro FPV Flight Controller Brushed Flight Control Board Tiny Whoop Flight Controller High-Performance Brushed Flight Controller For Micro Drones