- Driver Chip: ENC28J60
- Supply Voltage: 3.3V
- Crystal Oscillator: 25 MHz
- Ethernet Port: HanRun HR911105A
Description:
This module contains what you need to enable ethernet on your next microcontroller project. This board utilizes the new Microchip ENC28J60 Stand-Alone Ethernet Controller IC featuring a host of features to handle most of the network protocol requirements. The board connects directly to most microcontrollers with a standard SPI interface with a transfer speed of up to 20 MHz. It includes an ENC28J60 ethernet controller, an RJ45 socket with link/activity lights and integrated transformer. This ethernet module enables you to connect a particular Embedded device (equipped with SPI support) on to a network. By using this Ethernet module (along with a microcontroller running a small TCP/IP stack) applications like Embedded Web server can be easily developed. Use this module to enable Ethernet interface for your product. It works with any microcontroller operating at 3.3V or 5V. This module works at 5V and is compatible with 5V interface lines. Use the SPI process to interface with it. Host web server, ping the module or add it to home automation via the internet. Heart of this module is ENC28J60 Ethernet controller from Microchip. Use of RJ45 with Integrated transformer has made it possible to reduce the size of the board. This board is assembled with all components as shown in the pictures below. The circuit board includes all required components for the ethernet controller, plus a 3.3V Voltage Regulator and an RJ-45 jack with an integrated transformer and built-in Link and Activity LEDs for connection to an Ethernet Local Area Network.
Specification:
- Driver Chip: ENC28J60
- Supply Voltage: 3.3V
- Crystal Oscillator: 25 MHz
- Ethernet Port: HanRun HR911105A
Features:
- Microchip ENC28J60 Ethernet Chip supporting Microchipâs TCP/IP protocol stack, with IPv4, UDP, TCP, DHCP, ICMP, FTP, and HTTP support
- Compatible with all controllers having an SPI interface, SPI interface takes only a few pins to add Ethernet interface to your microcontroller project
- Suitable for 3.3V Interface
- LAN connector with build in a transformer
- Link and Activity LED's on Ethernet connector
- 8 pin standard interface connector with the spacing of 0.1â (2.54 mm) row pins
- IEEE 802.3 Compatible with Integrated MAC and 10Base-T PHY
- Fully Compatible with 10/100/1000Base-T Networks
- Supports One 10Base-T Port with Automatic Polarity Detection and Correction
- Supports Full and Half-Duplex modes
- Programmable Automatic Retransmit on Collision
- Programmable Padding and CRC Generation
- Programmable SPI Interface with Clock Speeds Up to 20 MH
Package Included:
1 x Ethernet LAN Module ENC28J60 Network RJ45 SPI Arduino UNNA003O 2560 AVR ARM PIC