
Elecrow Pi Power M.2 NVMe and PoE+ HAT for Raspberry Pi 5
The Elecrow MRA01305D adds an M-Key NVMe connection and Power over Ethernet to a Raspberry Pi 5 project. It connects to the Pi 5's PCIe interface with a ribbon cable and uses a compatible PoE network connection to power the assembly. It is useful for compact storage servers, embedded gateways and other wired Raspberry Pi installations.
Raspberry Pi 5, SSD, cooler, Ethernet cable and PoE power source are not included. This is an expansion HAT, not a complete computer or network switch. It supports M.2 NVMe PCIe drives, not M.2 SATA/NGFF drives. Drive compatibility and boot behaviour depend on the SSD, cable, operating system and bootloader.
Features
- Designed for Raspberry Pi 5 with mounting positions for 2230, 2242, 2260 and 2280 NVMe SSDs.
- Integrated PoE module supporting IEEE 802.3af/at, with power and data carried by the Ethernet connection.
- 40-pin GPIO header access for expansion, plus labelled power connections.
- Manufacturer-rated power output of 5V/5A or 12V/2A. Available power depends on the PoE source and system load; do not treat these as simultaneous output budgets.
- Layout supports the official Raspberry Pi 5 cooling solution, which is sold separately.
- Exact-model installation, wiring and NVMe troubleshooting instructions are available from Elecrow.
Specifications
| Manufacturer model | MRA01305D |
|---|---|
| Host compatibility | Raspberry Pi 5 |
| Storage interface | M-Key M.2 NVMe PCIe, 2230 / 2242 / 2260 / 2280 |
| Unsupported storage | M.2 SATA/NGFF drives |
| PoE standard | IEEE 802.3af/at |
| PoE input | 37V to 57V DC, per manufacturer |
| Power interfaces | GND, 12V, 5V and 3.3V connections |
| Board size | 56.6 × 88mm |
| Net weight | Approximately 41g |
| Operating temperature | 0°C to 50°C, per manufacturer |
Package Includes
- 1 × Pi Power M.2 NVMe and PoE+ HAT
- 1 × 16-pin PCIe ribbon cable, shown pre-installed in the manufacturer's package reference
- 2 × CM2 × 4 flat-head screws
- 8 × CM2.5 × 4 screws
- 4 × M2.5 × 16 double-pass copper pillars
Manufacturer application images show a Pi, SSD and network hardware as installation examples only. These are not additional package contents.
Installation and Setup
Disconnect all power before fitting the HAT, SSD or ribbon cable. Follow the exact-model wiring diagram for cable orientation, align the GPIO connector carefully and secure the board with the supplied mounting hardware. Keep exposed contacts away from metal cases. Use a suitable IEEE 802.3af/at PoE source rather than an undocumented passive injector.
Start with a current Raspberry Pi OS and bootloader. The manufacturer's guide explains enabling PCIe, detecting the SSD and selecting NVMe boot. Begin with the default PCIe Gen2 configuration. Gen3 is not guaranteed to be stable with every drive and cable. Partitioning, formatting and writing an OS can erase the SSD, so back up existing data before following those parts of the guide.