
DFRobot Fermion SEN0570 MEMS Smoke Sensor
The SEN0570 is a compact analog-output breakout for experiments that monitor a response to smoke and ethanol vapour. Its MEMS sensing element fits on a 13 × 13 mm board, making it useful for small microcontroller prototypes.
Important: This sensor gives a qualitative gas response. It is not a factory-calibrated ppm meter, particle counter or certified smoke alarm. DFRobot says not to use this module in systems involving personal safety. Do not use it as a replacement for a certified fire alarm or safety interlock.
Features and specifications
| Manufacturer / model | DFRobot Fermion SEN0570 |
|---|---|
| Target response | Smoke and ethanol (EtOH) |
| Measurement type | Qualitative response, analog voltage output |
| Manufacturer detection range | 10-1000 ppm; not a calibrated concentration reading |
| Supply | 3.3-5 V DC |
| Operating current | Less than 20 mA |
| Connections | A: analog output; VCC: supply; GND: ground |
| Operating conditions | -10 to 50 °C; 15-90% RH, non-condensing |
| Dimensions | 13 × 13 × 2.5 mm |
Using the sensor
Remove the protective film before use. Connect the output to a compatible controller ADC and check the ADC voltage limit before applying power. The analog reading indicates a sensor response, not a selective or calibrated measurement of smoke concentration.
- Keep away from silicone vapours, corrosive gases, alkalis, salts and halogens.
- Avoid water, condensation, freezing, strong vibration and prolonged hot, humid or polluted conditions.
- After long storage, DFRobot recommends preheating the sensor for at least 24 hours before use.
Package Includes
- 1 × DFRobot Fermion SEN0570 MEMS smoke sensor breakout
- 1 × 2.54 mm pitch pin header, supplied separately
Header soldering is required. Controller, wires, USB cable and power supply are not included. The connection diagram is a wiring reference, not a picture of included accessories.