
The DFRobot Gravity SEN0262 is an analog current-to-voltage converter built for 4-20mA current loop sensors. It linearly converts a 0-25mA current signal into a 0-3V voltage output, so any microcontroller with an analog input (Arduino, ESP32, micro:bit and more) can read industrial 4-20mA sensors directly.
In a 4-20mA loop, current below 4mA usually indicates a fault and current above 20mA indicates an overrun. With its wide 0-25mA detection range, this module supports both fault diagnosis and overrun detection applications.
The board uses a 0.1% high-precision sense resistor and an ultra-low noise, rail-to-rail, zero-drift op amp, giving high accuracy with no calibration required. A wide 3.3V-5.5V supply range and 0-3V analog output make it compatible with most main control boards. For higher resolution than a standard 10-bit ADC, pair it with a 15 or 16-bit ADC module over I2C.
Features
- Converts 0-25mA current signals to 0-3V voltage output
- Wide 3.3-5.5V supply voltage
- 0.1% high-precision sense resistor with ultra-low noise rail-to-rail zero-drift op amp
- High accuracy, no calibration needed
- 0-25mA measurement range supports fault diagnosis and overrun detection
- Gravity PH2.0-3P interface with included cable
Specifications
- Model: SEN0262
- Supply Voltage: 3.3V - 5.5V
- Detection Range: 0-25mA DC
- Output: 0-3V analog voltage
- Measurement Accuracy: ±0.5% F.S. @ 16-bit ADC, ±2% F.S. @ 10-bit ADC
- Termination Resistance: 120Ω
- Connector: PH2.0-3P
- Dimensions: 30mm x 22mm (1.18 x 0.87 inch)
Package Includes
- 1 x Gravity Analog Current to Voltage Converter (SEN0262)
- 1 x Digital Sensor Cable 3-pin (PH2.0)
Useful Links