
The CUAV C-RTK 2HP is a dual-antenna GNSS positioning and heading module for compatible unmanned systems. One module processes two antenna inputs, allowing satellite-based yaw estimation without needing a second GNSS module. Its STM32F4 processor supports DroneCAN and UART connections, with an RM3100 magnetic compass available as a backup heading source.
This set includes the module, two GNSS antennas and the cables itemized below. It does not include a flight controller or RTK base station. Heading can work without a base station, but centimeter-level RTK positioning requires suitable correction data and a valid RTK fix.
Features
- Multi-constellation, multi-frequency GNSS reception with two antenna inputs.
- Single-module dual-antenna heading for use where magnetic interference makes compass-only heading difficult.
- DroneCAN or UART controller connection; CAN is recommended in the CUAV setup guide.
- RM3100 magnetic compass for a configured backup heading source.
- USB and UART automatic switching, with AP_Periph open-source firmware support.
- Position update rate up to 20Hz, with a 5Hz default.
Specifications
- Model: CUAV C-RTK 2HP
- Processor: STM32F4
- GNSS receiver: high-precision GNSS SoC, 1408 channels
- GNSS systems: BDS, GPS, GLONASS, Galileo and QZSS
- Master antenna bands: BDS B1I/B2I/B3I; GPS L1C/A, L2P/L2C, L5; GLONASS L1/L2; Galileo E1/E5a/E5b; QZSS L1/L2/L5
- Secondary antenna bands: BDS B1I/B2I/B3I; GPS L1C/A/L2C; GLONASS L1/L2; Galileo E1/E5b; QZSS L1/L2
- Manufacturer-listed RMS accuracy: standalone 1.5m horizontal / 2.5m vertical; DGPS 0.4m + 1ppm horizontal / 0.8m + 1ppm vertical; RTK 0.8cm + 1ppm horizontal / 1.5cm + 1ppm vertical
- Correction data: RTCM 3.x
- Data protocols: DroneCAN and NMEA
- Ports: 2 antenna inputs, 1 CAN, 1 UART, 1 DSU and 1 USB
- Operating voltage: 4.7-5.2V
- Operating temperature: -20 to 85 degrees C
- Module dimensions: 50 x 37 x 17mm
- Module weight: 40g
Setup and Compatibility Notes
CUAV specifies ArduPilot 4.4.0 or later. Check the exact flight controller, connector pinout, firmware and parameters before installation. Secure both antennas with more than 30cm separation and a clear sky view. Configure the primary-to-secondary antenna direction and any heading offset for the actual installation. Accuracy depends on antenna placement, environment, correction quality and configuration.
RTK correction data may come from a compatible separate base or an available NTRIP/CORS service. This product is intended primarily as a rover/heading module, not as a ready-to-use base station. Correction-service coverage, accounts and fees are not included. No guaranteed range or universal flight-controller compatibility is claimed.
Package Includes
- 1 x CUAV C-RTK 2HP GNSS positioning and heading module.
- 2 x GNSS antennas.
- 2 x antenna cables, 50cm each.
- 1 x USB Type-C cable.
- 1 x CAN cable, 35cm.
- 1 x UART cable, 40cm.
No RTK base station, flight controller, aircraft, battery, antenna mounting structure or correction-service subscription is included. The first gallery image arranges the included physical parts on white; diagrams show module dimensions and pinouts, not additional equipment.