
The Axisflying MANTA5 Pro is a 5-inch Squashed X FPV frame kit for freestyle and cinematic builds. It uses T700 carbon fiber with 6mm arms, a 2mm top plate and a 3mm bottom plate, on a 226.5mm wheelbase, with an aluminium MANTA PRO base plate and a front camera section that takes DJI O3 or 19mm camera side plates. This is an unpowered frame kit that requires assembly, not a complete drone.
Key features
- Squashed X structure, 226.5mm wheelbase, propeller mounting for up to 5.1 inch.
- T700 carbon fiber: 6mm arms, 2mm top plate, 3mm bottom plate; frame weight about 212g (plus or minus 5g) including exterior parts and aluminium parts.
- Stack mounting 20x20mm with M3 holes; stack height 23mm.
- VTX mounting holes 20x20mm (M2 or M1.6) and 25x25mm (M2).
- Motor mounting holes 16x16mm with M3 screws.
- Camera section for 19mm and 20mm thick cameras, with side plates for DJI O3 and 19mm cameras included in the packing diagram.
- TPU GoPro-style mount, TPU arm guards and XT60 holder shown in the supplier packing diagram.
Recommended setup
Axisflying recommends 2207 series motors, a 6S 1050-1550mAh battery and an Axisflying Argus Mini 55A stack for this frame.
Package contents
As shown in the supplier packing diagram: 1 x MANTA PRO gift box, carbon top plate and bottom plate, 4 x carbon arms, aluminium base plate and aluminium bottom pieces, front camera side plates (DJI O3 and 19mm options), TPU parts (GoPro-style mount, tail and side parts, arm guards), 2 x battery straps, 4 x battery pads, 8 x standoffs, XT60 holder, 2 x antenna cables (IPEX to SMA), LED board, and a hardware set: M1.6x5 (2), M1.6x8 (4), M2x4 (2), M2x5 (4), M2x7 (1), M3x6 flat head (6), M3x6 (4), M3x9 (8), M3x10 (10), M3x10 (4), M3x16 (4) and M3x30 (4) screws.
Not included: motors, propellers, flight controller, ESC, receiver, VTX or DJI O3 air unit, camera, GPS module, action camera, battery and assembly tools. Photos show the bare frame kit only; no electronics are part of this kit. Assembly is required.