L298N Dual H Bridge DC Stepper Motor Controller Module for Arduino - AA034

0 Review(s)

Rs 140

AA034

New product

  • Chip: L298N 
  • Logic voltage: 5V 
  • Logic current 0mA-36mA 
  • Storage Temperature: -20 ℃ to ℃ to +135 
  • Operating mode: H-bridge driver (dual) 
  • Drive voltage: 5V-35V 
  • Drive current: 2A (MAX single bridge) 
  • Maximum power: 25W 

More details

By buying this product you can collect up to 1 loyalty point. Your cart will total 1 loyalty point that can be converted into a voucher of Rs 1.


Description :

Dual-channel H-bridge driver working mode creates higher working efficiency, L298N as main chip, ST corporation production. Can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors. To avoid damage the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage. Use large-capacity filter capacitors and diode with freewheeling protection function, increasing reliability. High working power to 46v, a large current can reach 3A MAX and continue current is 2A, a power to 25w. Large capacity filter capacitance, after flow protection diode, more stable and reliable.

Specfication :

  • Chip: L298N 
  • Logic voltage: 5V 
  • Logic current 0mA-36mA 
  • Storage Temperature: -20 ℃ to ℃ to +135 
  • Operating mode: H-bridge driver (dual) 
  • Drive voltage: 5V-35V 
  • Drive current: 2A (MAX single bridge) 
  • Maximum power: 25W 

Pin Description :

Note: 

  • This module has a built-in 5v power supply, when the driving voltage is 7v-35v, this supply is suitable for power supply
  • DO NOT input voltage to +5v supply interface, however ledding out 5v for external use is available.
  • When ENA enable IN1 IN2 control OUT1 OUT2
  • When ENB enable IN3 IN4 control OUT3 OUT4

Package Included :

1 x  L298N Dual H Bridge DC Stepper Motor Controller Module

HOW TO USE IT:

No customer reviews for the moment.

Write a review

L298N Dual H Bridge DC Stepper Motor Controller Module for Arduino - AA034

L298N Dual H Bridge DC Stepper Motor Controller Module for Arduino - AA034

  • Chip: L298N 
  • Logic voltage: 5V 
  • Logic current 0mA-36mA 
  • Storage Temperature: -20 ℃ to ℃ to +135 
  • Operating mode: H-bridge driver (dual) 
  • Drive voltage: 5V-35V 
  • Drive current: 2A (MAX single bridge) 
  • Maximum power: 25W 
Compare